cisco 6500 switch ios image download for gns3

Once you’ve booted into Switch ROM mode you’ll need to initialize the flash file system by executing the flash_init command as shown below įlashfs: 0 orphaned files, 0 orphaned directoriesįlashfs: flashfs fsck took 10 seconds. The flash filesystem, and finish loading the operating The system has been interrupted prior to initializing theįlash filesystem. The password-recovery mechanism is enabled. Once you’ve booted your switch into Switch ROM mode you’ll be see the following dispatch īoot Sector Filesystem (bs) installed, fsid: 2īase ethernet MAC Address: 00:14:f2:d2:41:80 You can check out the required procedure by clicking HERE! This typically involves holding down the STAT button on the front of the switch when plugging in the power. Unfortunately fixed configuration switches require the use of xModem to restore a corrupt or missing IOS images unlike the Cisco 4500 and Cisco 6500 Series supervisor engines which use compact flash cards Recovering the Cisco IOS Image on a fix configuration Cisco Catalyst Series Switch is quite a bit different and more of an “old school” way of doing an IOS image recovery. Boot the switch and verify that the switch boots properly.Unset the baud so that it defaults back to 9600.Set the boot parameter to the new image name located in Flash:.Copy the Cisco IOS Image via xModem to Flash:.Set the baud rate to 115200 to increase xmodem transfer speed and decrease time required to restore the IOS Image.

(This will remove your startup configuration)

OPTIONAL – Format the flash file system if needed.

Cisco 6500 switch ios image download for gns3